User manual

Remote Control Commands
R&S
®
Scope Rider RTH
196User Manual 1326.1578.02 ─ 04
CALCulate:MATH:VERTical:RANGe <Position>
Sets the voltage range across the 8 vertical divisions of the diagram. Use the com-
mand alternatively to CALCulate:MATH:VERTical:SCALe.
Parameters:
<Position> Voltage value of the range
Usage: SCPI confirmed
CALCulate:MATH:VERTical:POSition <Position>
Moves the math waveform or down in the diagram.
Parameters:
<Position> Position value, given in divisions.
Usage: SCPI confirmed
12.4.5 Reference Waveforms
REFCurve:SOURce....................................................................................................... 196
REFCurve:UPDate.........................................................................................................196
REFCurve:STATe.......................................................................................................... 196
REFCurve:POSition....................................................................................................... 197
REFCurve:NAME...........................................................................................................197
REFCurve:SAVE............................................................................................................197
REFCurve:OPEN........................................................................................................... 197
REFCurve:DELete......................................................................................................... 197
REFCurve:SOURce <Source>
Selects the waveform to be taken as reference waveform.
Parameters:
<Source> C1 | C2 | C3 | C4 | M1
*RST: C1
REFCurve:UPDate
Creates the reference waveform from the source waveform.
Usage:
Event
REFCurve:STATe <State>
Activates or deactivates the reference waveform.
Parameters:
<State> ON | OFF
Waveform Analysis