User manual

Remote Control Commands
R&S
®
Scope Rider RTH
205User Manual 1326.1578.02 ─ 04
In R&S RTH1002, the multimeter ia active as soon as the the "Meter" mode is on
(OP[:MODE]).
Suffix:
<m>
.
1..4
Selects the voltmeter.
Parameters:
<State> ON | OFF
*RST: OFF
METer<m>:SENSe:SOURce
<InputChannel>
Only relevant for R&S RTH1004: Selects the input channel to be measured by the
specified voltmeter.
In R&S RTH1002, the source is always the multimeter input, the command can be
omitted.
Suffix:
<m>
.
1..4
Selects the voltmeter.
Parameters:
<InputChannel> C1 | C2 | C3 | C4
*RST: C1
METer<m>:SENSe:RANGe <MeterRangeUI>
Sets the measurement range for the meter.
In R&S RTH1004, the command adjusts the range of the input channel that is mea-
sured by the meter.
Suffix:
<m>
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Parameters:
<MeterRangeUI> The range depends on the selected measurement type.
Range: 0.1 to 300
Increment: 0.1
*RST: 0.1
METer<m>:READ?
Starts a new measurement, returns the current measurement result and deletes the
memory.
Multimeter Measurements