User manual

Remote Control Commands
R&S
®
Scope Rider RTH
207User Manual 1326.1578.02 ─ 04
LOGGer:SOURce <Source>
Sets the logger source.
Parameters:
<Source> SCOPe | METer
LOGGer:TIMebase:SRATe <NextSampleRate>
Sets the number of samples per second.
Parameters:
<NextSampleRate> SA1 | SA2 | SA5 | SA10
*RST: SA1
LOGGer:TIMebase:SCALe <NextHorizScale>
Selects the horizontal scale of the logged data.
Parameters:
<NextHorizScale> AUTO | S1 | S2 | S4 | S5 | S10 | S20 | S40 | M1 | M2 | M4 | M5 |
M10 | M20 | M40 | H1 | H2 | H4 | H5 | H10 | H20 | D1 | D2 | D4
S1 | S2 | S4 | S5 | S10 | S20 | S40
Seconds per division
M1 | M2 | M4 | M5 | M10 | M20 | M40
Minutes per division
H1 | H2 | H4 | H5 | H10 | H20
Hours per division
D1 | D2 | D4
Days per division
*RST: AUTO
LOGGer:SLOT:CURRent <SelectedSlot>
Selects one of the 10 memory slots to store the data during the logging. It is possible to
change the slot during recording.
Parameters:
<SelectedSlot> SLOT1 | SLOT2 | SLOT3 | SLOT4 | SLOT5 | SLOT6 | SLOT7 |
SLOT8 | SLOT9 | SLOT10
*RST: SLOT1
LOGGer:SLOT:LOAD
Loads the stored log data of a slot. The slot is defined using LOGGer:SLOT:CURRent.
Usage:
Event
Data Logging