User manual

Remote Control Commands
R&S
®
Scope Rider RTH
226User Manual 1326.1578.02 ─ 04
Parameters:
<StopBits> B1 | B15 | B2
*RST: B1
BUS:UART:ORDer <BitOrder>
Defines if a word starts with MSB (most significant bit) or LSB (least significant bit).
The display of the decoded signal considers this setting, results are displayed in the
specified order.
Parameters:
<BitOrder> LSBF | MSBF
*RST: MSBF
BUS:UART:FRAMemode
<FrameMode>
IDLE defines frames of several words in the data stream, which are defined by a time-
out between a stop bit and the next start bit. Enter the minimum timeout between two
frames using BUS:UART:TOUT.
Parameters:
<FrameMode> NONE | IDLE
*RST: NONE
BUS:UART:TOUT <IdleTime>
Sets the minimum timeout between two frames if BUS:UART:FRAMemode is set to
IDLE.
Parameters:
<IdleTime> Range: 100E-9 to 1
Increment: 1E-3
*RST: 1E-3
Default unit: s
12.9 Logic Analyzer (R&S RTH-B1 MSO)
LOGic:THCoupling......................................................................................................... 226
LOGic:GROup<m>:TECHnology..................................................................................... 227
LOGic:GROup<m>:USER...............................................................................................227
LOGic:GROup<m>:THReshold?......................................................................................227
LOGic:GROup<m>:HYSTeresis.......................................................................................228
POD:STATe?................................................................................................................ 228
LOGic:THCoupling <ThresCoup>
Couples the threshold and hysteresis settings for the logic channels.
Logic Analyzer (R&S RTH-B1 MSO)