User manual

Getting Started
R&S
®
Scope Rider RTH
27User Manual 1326.1578.02 ─ 04
When using the wheel, always observe the position of the focus - the orange frame or
other highlighting that marks the active object on the screen.
●
If the focus is on the menu button or somewhere in the menu or dialogs:
– Turn the wheel to move the focus.
– Press the wheel button to apply the selection.
●
If the focus is on an element in the diagram, for example, on a waveform, cursor
line, or trigger level:
– Turn the wheel to change the position of the active element.
– Press the wheel button to toggle the active element, for example, to toggle the
cursor lines, or zoom size and zoom position.
The BACK key closes open dialogs and menus, and resets the focus to the "Menu"
button.
Menu navigation
The following procedure describes how to access and navigate the menu. Navigating
dialogs and selecting parameter values works in the same way. See also Figure 1-10.
1. Press BACK until the focus is on the "Menu" button.
2. Press the wheel button to open the menu.
3. Turn the wheel to move the focus to the required menu item.
4. Press the wheel button to open the dialog, submenu, or keypad for the selected
menu item.
Operating Basics