User manual

Waveform Setup
R&S
®
Scope Rider RTH
51User Manual 1326.1578.02 ─ 04
2.5.3 Glitch Trigger
The glitch trigger detects pulses shorter or longer than a specified time. It identifies
deviation from the nominal data rate and helps to analyze causes of even rare glitches
and their effects on other signals.
Description of settings
Polarity
Sets the pulse polarity, that is the direction of the first pulse slope. You can trigger on:
●
Positive going pulses. The width is defined from the rising to the falling edge.
●
Negative going pulses. The width is defined from the falling to the rising edge.
●
Both positive and negative going pulses
Remote command:
TRIGger:GLITch:POLarity on page 171
Range
Selects the glitches to be identified: shorter or longer than the specified "Width"
on page 51.
Remote command:
TRIGger:GLITch:RANGe on page 172
Width
Sets the pulse width of the glitch.
Remote command:
TRIGger:GLITch:WIDTh on page 172
Trigger