User manual

Waveform Setup
R&S
®
Scope Rider RTH
53User Manual 1326.1578.02 ─ 04
min
max
min
max
1 2
Figure 2-5: Pulse width is inside or outside a range
1 = Inside, pulse > min width AND pulse < max width
2 = Outside, pulse < min width OR pulse > max width
±Δ
1 2
±Δ
Figure 2-6: Pulse width is equal or unequal to a given width, with optional tolerance
1 = Equal, pulse > width - Δ AND pulse < width + Δ
2 = Unequal, pulse < width - Δ OR pulse > width + Δ
Remote command:
TRIGger:WIDTh:RANGe on page 172
Width
Sets the width for comparisons equal, unequal, shorter, and longer.
Remote command:
TRIGger:WIDTh:WIDTh on page 173
±Tolerance
Sets a range Δt to the specified Width if the comparison range is equal or unequal. To
trigger on an exact pulse width, set the tolerance to 0.
Remote command:
TRIGger:WIDTh:DELTa on page 173
Min Width / Max Width
Set the lower and upper time limits defining the time range if "Inside" or "Outside" is set
for comparison.
Remote command:
TRIGger:WIDTh:MIN on page 174
TRIGger:WIDTh:MAX on page 173
2.5.5 Video/TV Trigger
The TV or video trigger is used to analyze analog baseband video signals. You can
trigger on baseband video signals from standard definition and high definition stand-
ards, and also on user defined signals.
Trigger