Datasheet

Version 08.00, March 2016
6 Rohde & Schwarz R&S
®
RTH1002, R&S
®
RTH1004 Scope Rider
TV/video triggers on baseband analog progressive and interlaced video signals PAL, NTSC,
SECAM, PAL-M, SDTV and HDTV broadcast standards
(SDTV and HDTV require R&S
®
RTH-K19 option)
trigger events all fields, odd fields, even fields, all lines,
line number
Pattern triggers when a logical combination (and, nand, or, nor) of the input channels stays true
for a period of time shorter, longer, inside or outside a specified range
(requires R&S
®
RTH-K19 option)
pattern time 800 ps to 5000 s
State triggers when a logical combination (and, nand, or, nor) of the input channels stays true
at a slope (positive, negative or either) in one selected channel; state values may be
high (H), low (L) or don’t care (X) (requires R&S
®
RTH-K19 option)
Runt triggers on pulse of positive, negative or either polarity that crosses one threshold but
fails to cross a second threshold before crossing the first one again; runt pulse width
can be arbitrary, shorter, longer, inside or outside the interval
(requires R&S
®
RTH-K19 option)
runt pulse width 200 ps to 5000 s
Slew rate triggers when the time required by a signal edge to toggle between user-defined upper
and lower voltage levels is shorter, longer, inside or outside the interval; edge slope
may be positive, negative or either (requires R&S
®
RTH-K19 option)
toggle time 200 ps to 5000 s
Window triggers when signal enters or exits a specified voltage range; triggers also when signal
stays inside or outside the voltage range for a specified period of time
(requires R&S
®
RTH-K19 option)
window time 200 ps to 5000 s
Data2clock triggers on setup time and hold time violations between clock and data present on any
two input channels; monitored time interval may be specified by the user with a step
size of 800 ps in the range from –124 ns to 124 ns around a clock edge
(requires R&S
®
RTH-K19 option)
Serial pattern triggers on serial data pattern up to 32 bit clocked by one input channel; pattern bits
may be high (H), low (L) or don’t care (X); clock edge slope may be positive, negative
or either (requires R&S
®
RTH-K19 option)
max. data rate < 250 Mbps
Timeout triggers when signal stays high, low or unchanged for a specified period of time
(requires R&S
®
RTH-K19 option)
timeout 200 ps to 5000 s
Interval triggers when time between two consecutive edges of same slope (positive or
negative) is shorter, longer inside or outside a specified range
(requires R&S
®
RTH-K19 option)
interval time 200 ps to 5000 s
Protocol see R&S
®
RTH-K1 and R&S
®
RTH-K2 options