User manual

Remote Commands
R&S
®
Spectrum Rider FPH
330User Manual 1321.1011.02 ─ 05.00
You have to set the frequency mode with [SENSe:]FREQuency:INPut:
MODE<1..3> on page 290 to channel first.
The numeric suffix at CHANnel is irrelevant for this command.
Parameters:
<ChannelNumber> Numeric value that selects the number of the channel to be ana-
lyzed.
*RST: Depends on the channel table.
Example: See [SENSe:]CHANnel:TABLe:SELect<1...3>
on page 330.
[SENSe:]CHANnel:TABLe:SELect<1...3>
<ChannelTable>
This command selects a channel table configured for the link direction you have
selected with [SENSe:]CHANnel:TABLe:SET on page 331.
Note that if you have previously selected a channel table with [SENSe:]CHANnel:
TABLe:SELect:DOWNlink on page 330 or [SENSe:]CHANnel:TABLe:SELect:
UPLink on page 331, this command replaces that file.
The numeric suffix at SELect is irrelevant for this command.
Parameters:
<ChannelTable> String containing the filename of the channel table.
*RST: ' '
Example:
CHAN:TABL:SET UP
Selects channel table selection for uplink signals.
CHAN:TABL:SEL 'TV China.CHNTAB'
Loads the channel table with the name 'TV China' for the uplink.
CHAN:TABL:SEL 'TV Italy.chntab'
or
CHAN:TABL:SEL:UPL 'TV Italy.chntab'
Both commands replace the uplink channel table 'TV China' with
'TV Italy'.
Downlink channel tables are not affected by the commands sent
so far.
FREQ:INP:MODE CHAN
CHAN 10
Select a particular uplink channel (e.g. #10) instead of a (center)
frequency.
To select an additional downlink channel table, use either:
CHAN:TABL:SET DOWN
CHAN:TABL:SEL 'TV Italy.chntab'
or
CHAN:TABL:SEL:DOWN 'TV Italy.chntab'
[SENSe:]CHANnel:TABLe:SELect:DOWNlink <ChannelTable>
This command selects a channel table configured for downlink signals.
Remote Control - Commands