User manual

ManualsBrandsROHDE & SCHWARZ ManualsLaboratory Test EquipmentRTB2K-102M Digital 100 MHz 18-channel 1.25 GSa/s 10 Mpts 10 Bit Digital storage (DSO), Multimeter funct

121

122

123

124

125

126

127

128

129

130

Applications

R&S

RTB2000

125User Manual 1333.1611.02 ─ 06

Width X

Changes the width of the mask in horizontal direction. The specified factor in divisions

is added to the positive x-values and subtracted from the negative x-values of the

mask limits in relation to the mask center. Thus, the left half of the mask is pulled to the

left, the right half is pulled to the right.

Remote command:

MASK:XWIDth on page 344

Width Y

Changes the width of the mask in vertical direction. The specified number of divisions

is added to the y-values of the upper mask limit and subtracted from the y-values of the

lower mask limit. Thus, the upper half of the mask is pulled upwards, the lower half is

pulled down, and the overall height of the mask is twice the "Width Y".

Remote command:

MASK:YWIDth on page 344

Save

Saves the mask in an instrument-specific format (MSK). The complete mask definition

- envelope waveform with width, stretch and position settings - is stored.

Remote command:

MASK:SAVE on page 345 and commands described in Chapter 15.9.1.5, "Masks",

on page 375.

Load Mask

Opens a file explorer to select a previously stored mask. The selected mask is loaded

and can be used for a subsequent test.

Remote command:

MASK:LOAD on page 345

Actions

Opens a submenu to select the actions to be taken when a violation against the mask

limits occurs.

"Sound"

Generates a beep sound at each violation.

"Stop"

Stops the waveform acquisition. Set the number of the stop violation.

Thus, you can ignore a number of violations before stop.

"Pulse"

Creates a pulse on the [Aux Out] connector. This selection sets the

configuration of the [Aux Out] connector to "Mask Violation".

"Screenshot"

Saves a screenshot according to the settings in "File" > "Screen-

shots".

"Save Wave-

form"

Saves the waveform data according to the settings in "File" > "Wave-

forms".

Remote command:

MASK:ACTion:SOUNd:EVENt:MODE on page 345

MASK:ACTion:STOP:EVENt:MODE on page 345

MASK:ACTion:STOP:EVENt:COUNt on page 346

MASK:ACTion:PULSe:EVENt:MODE on page 345

Mask Testing