User manual

Signal Generation (Option R&S RTB-B6)
R&S
®
RTB2000
249User Manual 1333.1611.02 ─ 06
"Counter"
Generates a 4-bit wide counter pattern at pins P0 to P3.
"Arbitrary"
Creates, saves or loads an arbitrary 4-bit wide pattern and outputs it
at pins P0 to P3.
"Manual"
Sets the high or low state for each pin.
"UART, SPI,
I2C, CAN, LIN,
Audio -I2S,
Audio- TDM"
Generates a bus signal for measurements without measurement
object.
Remote command:
PGENerator:FUNCtion on page 483
14.2.2 Settings for Square Wave Pattern
Access: "Menu" > "Pattern Gen." > "Pattern" = "Square Wave"
Frequency
Sets the frequency of the square wave.
The values of the "Frequency" and "Period" depend on each other, as:
Period = 1/ Frequency
If you change the value, the "Period" is adjusted accordingly.
Remote command:
PGENerator:PATTern:FREQuency on page 485
Period
Sets the period of the square wave. If you change the value, the "Frequency" is adjus-
ted accordingly.
Remote command:
PGENerator:PATTern:PERiod on page 485
Polarity
Sets normal or inverted polarity.
Pattern Generator