User manual

Remote Control Commands
R&S
®
RTB2000
356User Manual 1333.1611.02 ─ 06
Parameters:
<LinesPerAcquisition>Range: 1 to 20
Increment: 1
*RST: 1
DISPlay:CBAR:SPECtrogram[:POSition] <DividerPosition>
Defines the position of the divide bar on top of the spectrogram.
Parameters:
<DividerPosition> Vertical position in pixel, measured from the top edge. The verti-
cal display size is 800 px.
Default unit: px
15.8.4.2 Peak List Settings
SPECtrum:MARKer:RTABle:ENABle................................................................................356
SPECtrum:MARKer[:ENABle]..........................................................................................356
SPECtrum:MARKer:SOURce.......................................................................................... 356
SPECtrum:MARKer:SETup:MMODe................................................................................ 357
SPECtrum:MARKer:SETup:MLEVel................................................................................. 357
SPECtrum:MARKer:SETup:DISTance.............................................................................. 357
SPECtrum:MARKer:SETup:EXCursion.............................................................................357
SPECtrum:MARKer:SETup:MWIDth.................................................................................357
SPECtrum:MARKer:REFerence:SETup:CMPeak...............................................................357
SPECtrum:MARKer:REFerence:SETup:CSCReen............................................................ 358
SPECtrum:MARKer:RTABle:ENABle <ResultTable>
Shows the peak list.
Parameters:
<ResultTable> ON | OFF
*RST: OFF
SPECtrum:MARKer[:ENABle]
Enables the usage of markers.
Parameters:
<MarkerEnable> ON | OFF
SPECtrum:MARKer:SOURce
Defines the waveform type that is searched for peaks.
Parameters:
<Source> SPECtrum | MINHold | MAXHold | AVERage
*RST: SPEC
Applications