User manual

ManualsBrandsROHDE & SCHWARZ ManualsLaboratory Test EquipmentRTB2K-102M Digital 100 MHz 18-channel 1.25 GSa/s 10 Mpts 10 Bit Digital storage (DSO), Multimeter funct

401

402

403

404

405

406

407

408

409

410

Remote Control Commands

R&S

RTB2000

402User Manual 1333.1611.02 ─ 06

Usage: Setting only

15.11 Serial Bus Analysis

● General................................................................................................................. 402

● SPI (Option R&S RTB-K1).................................................................................... 404

● I²C......................................................................................................................... 416

● UART (Option R&S RTB-K2)................................................................................ 427

● CAN (Option R&S RTB-K3).................................................................................. 436

● LIN (Option R&S RTB-K3).................................................................................... 452

15.11.1 General

BUS:TYPE...............................................................................................................402

BUS:STATe..............................................................................................................402

BUS:FORMat...........................................................................................................403

BUS:LABel.............................................................................................................. 403

BUS:LABel:STATe.................................................................................................... 403

BUS:DSIGnals......................................................................................................... 403

BUS:DSIZe..............................................................................................................403

BUS:POSition.......................................................................................................... 404

BUS:RESult.............................................................................................................404

BUS:TYPE <Type>

Defines the bus or interface type for analysis. All buses require special option to the

instrument.

Suffix:

1 | 2

Parameters:

<Type> PARallel | CPARallel | I2C | SPI | SSPI | UART | CAN | LIN

*RST: PARallel

BUS:STATe <State>

Switches protocol decoding on or off.

Suffix:

1 | 2

Parameters:

<State> ON | OFF

*RST: OFF

Serial Bus Analysis