Manualshelf

User manual

ManualsBrandsROHDE & SCHWARZ ManualsLaboratory Test EquipmentRTB2K-102M Digital 100 MHz 18-channel 1.25 GSa/s 10 Mpts 10 Bit Digital storage (DSO), Multimeter funct
431432433434435436437438439440
Remote Control Commands
R&S
®
RTB2000
438User Manual 1333.1611.02 ─ 06
BUS<b>:CAN:SAMPlepoint <SamplePoint>
Sets the position of the sample point within the bit in percent of the nominal bit time.
See also: "Sample Point" on page 209.
Suffix:
<b>
.
1 | 2
Parameters:
<SamplePoint> Range: 10 to 90
Increment: 1
*RST: 50
Default unit: %
BUS<b>:CAN:BITRate
<BitRate>
Sets the number of transmitted bits per second.
Suffix:
<b>
.
1 | 2
Parameters:
<BitRate> Range: 100 to 5,04E06
Increment: Depends on the bit rate value
*RST: 50E03
Default unit: Bit/s
15.11.5.2 CAN - Trigger
To configure the protocol trigger, make sure to set first:
●
TRIGger:A:TYPE to BUS
●
TRIGger:A:SOURce to SBUS1 | SBUS2
TRIGger:A:CAN:TYPE....................................................................................................438
TRIGger:A:CAN:FTYPe..................................................................................................439
TRIGger:A:CAN:ITYPe................................................................................................... 439
TRIGger:A:CAN:ICONdition............................................................................................ 440
TRIGger:A:CAN:IDENtifier.............................................................................................. 440
TRIGger:A:CAN:DCONdition...........................................................................................440
TRIGger:A:CAN:DLC......................................................................................................440
TRIGger:A:CAN:DATA....................................................................................................441
TRIGger:A:CAN:ACKerror...............................................................................................441
TRIGger:A:CAN:BITSterror............................................................................................. 441
TRIGger:A:CAN:CRCerror.............................................................................................. 441
TRIGger:A:CAN:FORMerror............................................................................................442
TRIGger:A:CAN:TYPE <TriggerType>
Specifies the trigger mode for CAN.
Serial Bus Analysis