User manual

Waveform Analysis
R&S
®
RTB2000
92User Manual 1333.1611.02 ─ 06
The found events and the search conditions are shown in the result table at the bottom
of the display. The table shows the following result values: result number, time value,
and optional value depending on the search type (voltage, width).
During running acquisition, the results in the table are updated continuously, and the
events are marked at the top of the diagram by a brown triangle outline.
Figure 6-8: Search results and settings during running acquisition
Remote commands to get search results:
●
SEARch:RCOunt? on page 313
●
SEARch:RESult:ALL? on page 312
●
SEARch:RESult<n>? on page 313
●
SEARch:RESDiagram:SHOW on page 312
●
SEARch:RESult:BCOunt? on page 312
To display search results
When the acquisition is stopped, you can browse the search results.
1. Stop the acquisition.
2. Tap the search result that you want to analyze. If necessary, scroll the list.
The selected event is marked by a filled triangle and a magnifying glass.
Search