User manual

Fernsteuerbefehle
R&S
®
RTB2000
375Bedienhandbuch 1333.1611.03 ─ 05
Beispiel:
DVM:SOUR CH1
DVM:TYPE MEAN
DVM:RES:STAT?
<-- 4.968E-01,5
The result value of the mean measurement on channel 1 is
496.1 mV. The result status is 5 (decimal) = 0101 (binary). That
means, the result is valid (bit 0 = 1), and the signal is clipped by
the limits of the ADC range (bit 3 = 1).
Verwendung: Nur Abfrage
15.8.6 Triggerzähler
TCOunter:ENABle..........................................................................................................375
TCOunter:SOURce........................................................................................................ 375
TCOunter:RESult[:ACTual]:FREQuency?......................................................................... 375
TCOunter:RESult[:ACTual]:PERiod?................................................................................375
TCOunter:ENABle <Enable>
Enables or disables the trigger counter measurements.
Parameter:
<Enable> ON | OFF
TCOunter:SOURce
Sets the measurement source for the counter.
Parameter:
<CounterSource> CH1 | CH2 | CH3 | CH4 | TRIGger
TRIGger: Trigger source
*RST: TRIG
TCOunter:RESult[:ACTual]:FREQuency?
Returns the frequency of the trigger source.
Rückgabewerte:
<FrequencyValue> Std.-einheit: Hz
Verwendung: Nur Abfrage
TCOunter:RESult[:ACTual]:PERiod?
Returns the period of the trigger source.
Rückgabewerte:
<PeriodValue> Std.-einheit: s
Anwendungen