Manualshelf

User manual

ManualsBrandsROHDE & SCHWARZ ManualsLaboratory Test EquipmentRTB2K-102M Digital 100 MHz 18-channel 1.25 GSa/s 10 Mpts 10 Bit Digital storage (DSO), Multimeter funct
481482483484485486487488489490
Fernsteuerbefehle
R&S
®
RTB2000
489Bedienhandbuch 1333.1611.03 ─ 05
WGENerator:OUTPut:DESTination <Destination>
Sets the output connector for the function generator waveform.
Parameter:
<Destination> BNC | P3
WGENerator:OUTPut:LOAD <Load>
Select the user load, the load of the DUT at its connection. You can select either a
„50Ω“ or a „High-Z“ (high input impedance) load.
Parameter:
<Load> HIGHz | R50
WGENerator:OUTPut[:ENABle]
<OutputEnable>
Enables the function generator and outputs the waveform.
Parameter:
<OutputEnable> ON | OFF
WGENerator:SWEep:FEND <StopFrequency>
Sets the stop frequency of the sweep signal.
Parameter:
<StopFrequency>
WGENerator:SWEep:FSTart <StartFrequency>
Sets the start frequency of the sweep signal.
Parameter:
<StartFrequency>
WGENerator:SWEep:TIME <SweepTime>
Sets the duration of the sweep.
Parameter:
<SweepTime>
WGENerator:SWEep:TYPE <SweepType>
Sets the type of the sweep, a linear or logarithmic change of the frequency.
Parameter:
<SweepType> LINear | LOGarithmic
Signalerzeugung (Option R&S RTB-B6)