User Manual

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Normal Conditions
– 2.40 – 6076.0822.12.02
3 Press softkey
GUARD.
Select setting.
Selection of the guard receiver AF signal
that in communication mode V/D UNCP is
to be mixed to the main receiver AF signal.
2))
mixer and LED SQL G switched off
8+) AF signal from guard receiver
(UHF channel)
9+) AF signal from guard receiver
(VHF channel)
8+)9+) AF signals from guard receiver
(UHF and/or VHF channel)
Reception of an emergency call is indicated
by illumination of the SQL G LED, as well
as through a status message in the display.
4 Press softkey
POWER.
Select setting.
Selection of transmit power
2))
Tx is switched off
/2: Tx is set to low power
0(',80 Tx is set to medium power
+,*+ Tx is set to high power
Ç Exact levels in W are defined in Menu
516 (VU TX PARAMETERS).
5 Press softkey
MODU.
Select setting.
Selection of modulation type
$0 amplitude modulation
)0 frequency modulation
6 Press softkey
SQUELCH.
Switches the squelch function on or off
2))
noise without Rx signal, no muting
21 Audio signal only if RF signal level is
above squelch level
Ç The squelch level is set in Menu 515
(VU RX PARAMETERS).
7 Press softkey
TONE.
Produces test tone (1 kHz) for test and
monitoring purposes as long as softkey
TONE is pressed.
1RWH
7KLVWRQHLVWUDQVPLWWHGRQWKH
VHOHFWHGUDGLRIUHTXHQF\
8 Press softkey
MARKER.
Switches a marker tone on or off, if present.
When a marker tone is present, the softkey
automatically shows ON as the current set-
ting. The marker tone is output via a loud-
speaker or headset. By pressing this
softkey the marker tone is switched off until
the next one occurs.
No. Control Action Notes