User Manual

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Normal Conditions
6076.0822.12.02 – 2.43 / 2.44 –
 0HQX(0(5*(1&<02'(
In the EMERGENCY menu, frequency band and transmit power for making an emergency call
can be selected. Reception of an emergency call is indicated by illumination of the SQL G LED,
as well as through a status message in the display. When the operator then changes to the
EMERGENCY menu, that frequency where the call was received on will be automatically set.
Then the operator only has to press the PTT key to answer the emergency call. Depending on
the configuration in Menu 575 (FRONTPANEL AUDIO SOURCE), the emergency call will also
be made audible via the loudspeaker. Softkey GUARD (see Menu 110, page 1 (MANUAL
FIX.FRQ) and Menu 210, page 1 (USER PRESET FIX.FRQ)) is used to select the guard re-
ceiver AF signal that in communication mode V/D UNCP is to be mixed to the main receiver AF
signal on the Comline.
Starting point: Menu 040 (MAIN)
+ Press softkey (3)
q The following display appears:
No. Control Action Notes
2 Press softkey
BAND to select the
required band.
Tunes to emergency frequency of transmit-
ter (VHF or UHF):
VHF = 121.500 MHz
UHF = 243.000 MHz
1RWH
:KHQWKHUDGLRUHFHLYHVDQHPHUJHQF\FDOOHJRQ
0+]DQGWKHRSHUDWRUWKHQFKDQJHVWR0HQX
WKHIUHTXHQF\RI0+]ZLOOEHWXQHGDX
WRPDWLFDOO\+RZHYHULIWKHRSHUDWRUVWLOOZDQWVWRVH
OHFW0+]WKHQKHRQO\QHHGVWRSUHVV
VRIWNH\%$1'
3 Press softkey
POWER to select
the required power
level.
Selection of emergency transmit power
2))
Tx is switched off
/2: Tx is set to low power
0(',80 Tx is set to medium power
+,*+ Tx is set to high power
Ç The exact levels in W are set in Menu
516 (VU TX PARAMETERS).


Guard receiver band
Selected Comline
Transmit power level
Selected guard frequency