User Manual

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Special Conditions
– 3.12 – 6076.0822.12.01
8. Press key (front panel).
9. Press key again.
10. ENTER maintenance PIN by using
the numerical keypad, then press
ENTER.
11. Press softkeys
Menu 560 (AUDIO MAPPING)
12. Check if audio line WB1 is connected
with Comline CL1. If necessary, con-
nect.
13. Press softkey
Menu 550 (PTT COMLINE MAPPING)
14. Check if keyline PTT_1 is connected
with Comline CL1, if it is low-active
and only effective in remote mode. If
necessary, configure.
15. Press softkey
Menu 570 (SQUELCH POLARITY)
16. Select squelch SQ COMLINE 1 by us-
ing the tuning knob.
17. Press softkey to set the
squelch level to low.
18. Press softkeys
Menu 510 (RADIO MODULES)
19. Press softkey
20. Select module audio interface by us-
ing the tuning knob.
21. Press softkey
Menu 512 (AFI PARAMETERS)
22. Press softkey
23. Select audio line WB1 by using the
tuning knob.
24. Press softkey
25. Enter a new TX LEVEL by using the
numerical keypad, then press
ENTER.
Range: -3 dB to +15.5 dB
relative to 1.4 V
pp
1RWH
$SSUR[LPDWLRQWRWKHGLJLWDOLQSXWOHYHOZLOOVXIILFH
7KHVLJQDOZLOOEHGLJLWL]HGE\PHDQVRIDQLQWHUQDO
FRPSDUDWRU
26. Press softkey
27. Enter a new RX LEVEL by using the
numerical keypad, then press
ENTER.
Range: -3 dB to +15.5 dB
relative to 1.4 V
pp
28. Press softkey
29. Select module VU POWER
AMPLIFIER by using the tuning knob.
30. Press softkey
Menu 516 (VU TX PARAMETERS)
31. Press softkey
32. Enter a new modulation depth by us-
ing the numerical keypad, then press
ENTER.
Range: 10% to 99%; 90% recommended
0 dB = 1.4 V
pp
into 600 Ω
-3 dB = 1.0 V
pp
into 600 Ω
+15.5 dB = 8.0 V
pp
into 600 Ω