User Manual

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Special Conditions
– 3.58 – 6076.0822.12.02
 0HQX$8',20$33,1*
In this menu the assignment of audio channels to Comlines is displayed and edited.
Starting point: Menu 400, page 2
+ Press softkey (12) and the following display appears:
No. Control Action Notes
2 Press softkey
SOURCE.
Select setting.
Assigns the selected audio port to the
Comline.
&/
Audio port is dedicated to Comline CL1 modules. In
communication mode V/D UNCP any AF signal
from the guard receiver will be added to the nar-
rowband interface if the mixer is switched on via
softkey GUARD (Menus 110 / 210).
*8$5'
Audio port is exclusively for AF signals from the
guard receiver. Any AF signal from the guard re-
ceiver will be output at the NB2 port in all communi-
cation modes.
1RWH
:HUHFRPPHQGWRVZLWFKRQWKHPL[HUYLD
VRIWNH\*8$5'0HQXVIRU
ERWK$)VLJQDOV9+)DQG8+)
7KLVJXDUDQWHHVWKH$)VLJQDORXWSXWIURP
WKHJXDUGUHFHLYHULQDOOFRPPXQLFDWLRQ
PRGHV
9 Press softkey
SAVE.
Saves the current configuration.
The asterisk (*) indicates that the new set-
tings have not yet been stored.
softkey AUDIO MAPPING...


+ Select audio line
NB: Voice info
WB: Data info