User Manual

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Normal Conditions
6076.0822.12.01 – 2.3 –
For installation into a 19" rack with telescopic slides proceed as follows:
1. Take the right-hand telescopic slide and extend it as far as it goes.
2. Press the automatic unlocking device and pull the innermost slide completely out.
3. Attach the innermost slide to the right-hand side panel of the transceiver by means of four
Phillips screws and the associated washers (see figure above).
4. Take the left-hand telescopic slide and extend it as far as it goes.
5. Press the automatic unlocking device and pull the innermost slide completely out.
6. Attach the innermost slide to the left-hand side panel of the transceiver by means of four
Phillips screws and the associated washers (see figure above).
7. Take the outer telescopic slides and mount them to the rack.
8. Insert the transceiver, with its slides fitted, into the extended slides of the rack and slide
it in until the stop is reached.
9. Fasten the transceiver to the rack using four screws.
10. Cable the transceiver at its rear acc. to chapter 2.4.