User Manual

065 75$16&(,9(5  ; $  ; $

Operator’s Manual • Use under Normal Conditions

6076.0822.12.02 – 2.17 –

 .H\&RPELQDWLRQV

By hitting the following key combinations on Control Unit GB 4000C and the Front Panel, re-

spectively, special commands can be given to the M3SR Transceiver.

.H\FRPELQDWLRQRQ&RQWURO8QLW

RQO\; $

'HVFULSWLRQ  HIIHFWRQ065 7UDQVFHLYHU

(6&&/5 and 212))

(6&&/5 and .H\

The radio initiates an Emergency Clear.

This works always, i.e. also in a Monitoring Ses-

sion. No Advanced or Fixed Session is re-

quired.

Zeroize is available as output signal at connec-

tor contact X26.24 (AF1) (refer to interface de-

scription in Appendix A1).

In the case that a Cipher Unit KY58 is con-

nected, emergency clear will erase the KY58

data.

0(18+20( and (17 at the same time Initiates the procedure for system PIN number

input (see chapter 3).

System PIN numbers cannot be changed since

they are firmly tied to the hardware.

The following 4 keys at the same time:

8SSHU OHIW VRIWNH\ and 212)) and

XSSHU ULJKWVRIWNH\ and (17

Initiates a control unit RESET.

The control unit then re-establishes the remote

control connection to the radio and displays the

last menu active before the RESET.

.H\FRPELQDWLRQRQ

)URQW3DQHO 'HVFULSWLRQ  HIIHFWRQ065 7UDQVFHLYHU

6(/(&7 and 10 x /2&$/ within 10 sec Sets the default IP (Internet Protocol) address:

Platform CPLAT set to 192.168.52.46

This is necessary when incorrect IP addresses

were entered and the default IP address is to be

used again for establishing a remote control

connection to a radio.