User Manual

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Normal Conditions
– 2.36 – 6076.0822.12.02
4 Press softkey
POWER
Select setting.
Selection of transmit power
2))
Tx is switched off
/2: Tx is set to low power
0(',80 Tx is set to medium power
+,*+ Tx is set to high power
Ç Exact levels in W are defined in Menu
516 (VU TX PARAMETERS).
5 Press softkey
MODU.
Select setting.
Selection of modulation type
$0
amplitude modulation
)0 frequency modulation
6 Press softkey
SQUELCH.
Switches squelch function on or off.
2))
noise without Rx signal, no muting
21 Audio signal only if RF signal level is
above squelch level
Ç The squelch level is set in Menu 515
(VU RX PARAMETERS).
7 Press softkey
TONE.
Produces test tone (1 kHz) for test and
monitoring purposes as long as softkey
TONE is pressed.
1RWH
7KLVWRQHLVWUDQVPLWWHGRQWKHVHOHFWHG
UDGLRIUHTXHQF\
8 Press softkey
MARKER.
Switches a marker tone on or off, if present.
When a marker tone is present, the softkey
automatically shows ON as the current set-
ting. The marker tone is output via a loud-
speaker or headset. By pressing this
softkey the marker tone is switched off until
the next one occurs.
12 Press softkey
FREQ.
Set value.
Setting of a common frequency for Tx and
Rx operation in the frequency range from
q 100 to 512 MHz (VHF/UHF transceiver) or
q 108 to 173.9875 MHz (VHF transceiver) or
q 225 to 399.9875 MHz (UHF transceiver)
Ç The stepwidth is selected in Menu
110, page 2 (MANUAL FIX.FRQ).
1RWH
7KHWXQLQJNQREVHWWLQJQHHGVQRFRQILUPD
WLRQZLWK(17
No. Control Action Notes