Operating instructions

CALCulate:MARKer Subsystem R&S ESCI
1166.6004.12 6.60 E-1
Example: "CALC:MARK:FUNC:POW:SEL ACP" 'Switches on adjacent-channel power
measurement in window A.
Characteristics: *RST value: -
SCPI: device-specific
Mode:A-F
The parameters CN and CN0 are available only from firmware version 1.40.
CALCulate<1|2>:MARKer<1...4>:FUNCtion:POWer:RESult? ACPower | CPOWer | MCACpower |
OBANdwidth | OBWidth | CN | CN0
This command queries the result of the power measurement performed in the selected window.
If necessary, the measurement is switched on prior to the query.
The channel spacings and channel bandwidths are configured in the SENSe:POWer:ACHannel
subsystem.
To obtain a valid result, a complete sweep with synchronization to the end of the sweep must be
performed before a query is output. Synchronization is possible only in the single-sweep mode.
Parameters:
ACPower:
Adjacent-channel power measurement
Results are output in the following sequence, separated by commas:
1. Power of transmission channel
2. Power of lower adjacent channel
3. Power of upper adjacent channel
4. Power of lower alternate channel 1
5. Power of upper alternate channel 1
6. Power of lower alternate channel 2
7. Power of upper alternate channel 2
The number of measured values returned depends on the number of
adjacent/alternate channels selected with
SENSe:POWer:ACHannel:ACPairs.
With logarithmic scaling (RANGE LOG), the power is output in the
currently selected level unit; with linear scaling (RANGE LIN dB or LIN %),
the power is output in W. If SENSe:POWer:ACHannel:MODE REL is
selected, the adjacent/alternate-channel power is output in dB.
CPOWer
Channel power measurement
With logarithmic scaling (RANGE LOG), the channel power is output in the
currently selected level unit; with linear scaling (RANGE LIN dB or LIN %), the
channel power is output in W.
MCACpower:
Channel/adjacent-channel power measurement with several carrier signals
Results are output in the following sequence, separated by commas:
1. Power of carrier signal 1
2. Power of carrier signal 2
3. Power of carrier signal 3
4. Power of carrier signal 4
5. Power of carrier signal 5
6. Power of carrier signal 6
7. Power of carrier signal 7
8. Power of carrier signal 8
9. Power of carrier signal 9
10. Power of carrier signal 10
11. Power of carrier signal 11
12. Power of carrier signal 12
13. Total power of all carrier signals
14. Power of lower adjacent channel
15. Power of upper adjacent channel