Operating instructions

R&S ESCI INSTrument Subsystem
1166.6004.12 6.113 E-1
INSTrument:CONFigure<1|2>:DISPlay SANalyzer | RECeiver
This command selects the combination to be displayed in the mixed mode
(INSTrument:CONFigure:MIXed ON).
Two combinations are available:
Screen 1 (top) Screen 2 (bottom)
Bargraph Sweep
Sweep Scan
Sweep corresponds to the parameter SANalyzer, and Bargraph and Scan to the parameter
RECeiver.
If, for example, INST:CONF1 SAN is used to set the spectrum analyzer for screen 1, the scan
display is automatically selected for screen 2 – which is equivalent to INST:CONF2 REC. The same
applies conversely, allowing the desired display to be set using only one command.
Example: ""INST:CONF:DISP REC"
Characteristics: *RST value: REC
SCPI: device specific
Mode: R, A
INSTrument:CONFigure:MIXed ON | OFF
This command splits the screen and decouples the two subscreens, permitting a mixed
analyzer/receiver display.
Two combinations are available:
Screen 1 (top) Screen 2 (bottom)
Bargraph Sweep
Sweep Scan
The screens are selected with the INSTrument:CONFigure:DISPlay SANalyzer |
RECeiver command.
Example: ""INST:CONF:MIX ON"
Characteristics: *RST value: ON
SCPI: device specific
Mode: R, A
INSTrument:COUPle NONE | RLEVel | CF_B | CF_A
In operating mode SPECTRUM this command selects the parameter coupling between the two
measurement windows screen A and B.
Parameter: NONE No coupling. The two measurement windows are operated like
two independent "virtual" devices.
RLEVel The reference levels of the two measurement windows are
coupled.
CF_B The center frequency of screen B is coupled to the frequency of
marker 1 in screen A.
CF_A The center frequency of screen A is coupled to the frequency of
marker 1 in screen B.
Example: "INST:COUP NONE" 'Switches off the coupling of measurement windows.
'This leads to two independent "virtual" devices.
Characteristics: *RST value: NONE
SCPI: device specific
Mode: A