Operating instructions

R&S ESCI MMEMory Subsystem
1166.6004.12 6.119 E-1
MMEMory:DELete <file_name>
This command deletes the indicated files.
The indication of the file name contains the path and, optionally, the drive name. Indication of the
path complies with DOS conventions.
Parameter: <file_name> ::= DOS file name
Example: "MMEM:DEL 'TEST01.HCP'" 'The file TEST01.HCP is deleted.
Characteristics: *RST value: -
SCPI: conforming
Mode: all
This command is an event and therefore has no *RST value and no query.
MMEMory:INITialize <msus>
This command formats the disk in drive A. Formatting deletes all data stored on the floppy disk.
Parameter: <msus> ::= 'A:' Only drive name A: is accepted.
Example: "MMEM:INIT 'A:'"
Characteristics: *RST value: -
SCPI: conforming
Mode: all
This command is an event and therefore has no *RST value and no query.
MMEMory:LOAD:STATe 1,<file_name>
This command loads device settings from files.The contents of the file are loaded and set as the new
device state. The device automatically recognizes the files that are required for the whole setup from
the list of file extensions:
Contents Extension
Current setting of measurement hardware and associated title, if indicated .SET
Activated limit lines .LIN
Current configuration of general device parameters .CFG
Configuration for the hardcopy output .HCS
User-defined color setting .COL
All defined limit lines .LIA
Measured data trace 1 to trace 3 screen A .TR1 to 3
Measured data trace 1 to trace 3 screen B .TR4 to 6
Tracking generator settings (only with Tracking Generator Option B9 or Ext. Generator Control B10) .TCi
Setting for source calibration (only with Tracking Generator Option B9 or Ext. Generator Control B10) .TS1
.TS2
Correction data for source calibration (only with Tracking Generator B9 or Ext. Generator Control B10) .TC1; .TC2
Activated transducer factors .TF
Activated transducer set .TS
All defined transducer sets + transducer factors. TSA; .TFA
Peak list or final measurement results .FIN
The file name includes indication of the path and may also include the drive name. The path name
complies with DOS conventions.
Parameter: <file_name> ::= DOS file name without extension, extensions see table
Example: "MMEM:LOAD:STAT 1,'A:TEST'"
Characteristics: *RST value: -
SCPI: conforming
Mode: all
This command is an event and therefore has no *RST value and no query.