Operating instructions

SENSe:CORRection Subsystem R&S ESCI
1166.6004.12 6.160 E-1
[SENSe<1|2>:]CORRection:TRANsducer:DELete
This command deletes the selected transducer factor.
Example: ":CORR:TRAN:DEL"
Characteristics: *RST value: -
SCPI: device-specific
Modes: A
This command is an event and therefore has no *RST value. Prior to this command, the command
SENS:CORR:TRAN:SEL must be sent.
:[SENSe<1|2>:]CORRection:TRANsducer:VIEW ON | OFF
This command switches on the display of the active transducer factor or set.
Example: "CORR:TRAN:VIEW ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
Prior to this command, the command SENS:CORR:TRAN:SEL must be sent.
:[SENSe<1|2>:]CORRection:TRANsducer:RLEVel[:STATe] ON | OFF
This command switches on the automatic adjustment of the reference level to the selected
transducer factor.
Example: "CORR:TRAN:RLEV ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
Prior to this command, the command SENS:CORR:TRAN:SEL must be sent.
[SENSe<1|2>:]CORRection:TSET:SELect <name>
This command selected the transducer set designated by <name>. If <name> does not exist yet, a
new set is created.
Parameter: <name>::= name of the transducer set in string data form with a maximum
of 8 characters.
Example: ":CORR:TSET:SEL 'SET1'"
Characteristics: *RST value: -
SCPI: device-specific
Modes: R, A
This command must be sent prior to the subsequent commands for changing/activating the
transducer sets.