Operating instructions

SENSe:FREQuency Subsystem R&S ESCI
1166.6004.12 6.170 E-1
[SENSe<1|2>:]FREQuency:MODE CW | FIXed | SWEep
This command switches between single frequency measurement (CW) and scan (SCAN), if in EMI
receiver operating mode. In SPECTRUM mode it switches between frequency domain (SWEep) and
time domain (CW | FIXed).
In SCAN mode the frequency setup is performed using the commands FREQuency:STARt,
FREQuency:STOP in the SENSe:SCAN subsystem.
Example: "FREQ:MODE SWE"
Characteristics: *RST value: CW
SCPI: conforming
Mode: R, A
[SENSe<1|2>:]FREQuency:OFFSet <numeric_value>
This command defines the frequency offset of the instrument.
Example: "FREQ:OFFS 1GHZ"
Characteristics: *RST value: 0 Hz
SCPI: conforming
Mode: A, FM