Operating instructions

SENSe:POWer Subsystem R&S ESCI
1166.6004.12 6.182 E-1
[SENSe<1|2>:]POWer:ACHannel:SPACing[:ACHannel] 100 Hz to 2000 MHz
This command defines the channel spacing of the adjacent channel to the TX channel. At the same time,
the spacing of alternate adjacent channels 1 and 2 is set to the double or triple of the entered value.
The command is only available in the frequency domain (span > 0).
Example: "POW:ACH:SPAC:ACH 33kHz" 'Sets the spacing between the carrier signal
'and
'- the adjacent channel to 33 kHz
'- the alternate adjacent channel 1 to 66 kHz
'- the alternate adjacent channel 2 to 99 kHz
Characteristics: *RST value: 14 kHz
SCPI: device-specific
Mode: A-F
[SENSe<1|2>:]POWer:ACHannel:SPACing:ALTernate<1|2> 100 Hz to 2000 MHz
This command defines the spacing between the first (ALTernate1) or the second alternate adjacent
channel (ALTernate2) and the TX channel.If the spacing to the alternate adjacent channel ALTernate1 is
modified, the spacing to alternate adjacent channel 2 is set to 1.5 times the entered value.
This command is only available in the frequency domain (span > 0).
Example: "POW:ACH:SPAC:ALT1 100kHz"'Sets the spacing between TX channel and
'alternate adjacent channel 1 to 100 kHz and
'between TX channel and alternate adjacent
'channel 2 to 150 kHz.
Characteristics: *RST value: 40 kHz (ALT1)
60 kHz (ALT2)
SCPI: device-specific
Mode: A-F
[SENSe<1|2>:]POWer:ACHannel:TXCHannel:COUNt 1 | 2 | 3 | 4
This command selects the number of carrier signals.
The command is available only for multicarrier channel and adjacent-channel power measurements
(CALC:MARK:FUNC:POW:SEL MCAC) in the frequency domain (span > 0).
Example: "POW:ACH:TXCH:COUN 3"
Characteristics: *RST value: 4
SCPI: device-specific
Mode:A-F
[SENSe<1|2>:]POWer:ACHannel:ACPairs 0 | 1.| 2 | 3
This command sets the number of adjacent channels (upper and lower channel in pairs).The figure 0
stands for pure channel power measurement.
The command is only available in the frequency domain (span > 0).
Example: "POW:ACH:ACP 3" 'Sets the number of adjacent channels to 3, i.e. the
'adjacent channel and alternate adjacent channels 1 and
'2 are switched on.
Characteristics: *RST value: 1
SCPI: device-specific
Mode: A-F