Operating instructions

SENSe:POWer Subsystem R&S ESCI
1166.6004.12 6.184 E-1
[SENSe<1|2>:]POWer:ACHannel:REFerence:AUTO ONCE
This command sets the reference value for the relative measurement to the currently measured
channel power.
The command is only available in the frequency domain (span > 0).
Example: "POW:ACH:REF:AUTO ONCE"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-F
This command is an event and therefore has no *RST value and no query.
[SENSe<1|2>:]POWer:ACHannel:REFerence:TXCHannel:AUTO MINimum | MAXimum | LHIGhest
This command activates the automatic selection of a transmission channel to be used as a reference
channel in relative adjacent-channel power measurements.
The transmission channel with the highest power, the transmission channel with the lowest power,
or the transmission channel nearest to the adjacent channels can be defined as a reference channel.
The command is available only for multicarrier channel and adjacent-channel power measurements
(CALC:MARK:FUNC:POW:SEL MCAC) in the frequency domain (span > 0).
Parameters: MINimum Transmission channel with the lowest power
MAXimum Transmission channel with the highest power
LHIGhestLowermost transmission channel for the lower adjacent channels,
uppermost transmission channel for the upper adjacent channels
Example: "POW:ACH:REF:TXCH:AUTO MAX" 'The transmission channel with the
highest power is used as a reference
channel.
Characteristics: *RST value: -
SCPI: device-specific
Mode:A-F
[SENSe<1|2>:]POWer:ACHannel:REFerence:TXCHannel:MANual 1 | 2 | 3 | 4
This command selects a transmission channel to be used as a reference channel in relative
adjacent-channel power measurements.
The command is available only for multicarrier channel and adjacent-channel power measurements
(CALC:MARK:FUNC:POW:SEL MCAC) in the frequency domain (span > 0).
Example: "POW:ACH:REF:TXCH:MAN 3" 'Transmission channel 3 is used as a reference
channel.
Characteristics: *RST value: 1
SCPI: device-specific
Mode:A-F