Operating instructions

R&S ESCI STATus Subsystem
1166.6004.12 6.203 E-1
COMMAND PARAMETERS UNIT COMMENT
:SYNC
[:EVENt?]
:CONDition?
:ENABle
:PTRansition
:TRANsducer
[:EVENt?]
:CONDition?
:ENABle
:PTRansition
:NTRansitionSTATus
:QUEue
[:NEXT?]
--
--
0 to 65535
0 to 65535
--
--
0...65535
0...65535
0...65535
--
--
--
--
--
--
--
--
--
--
--
--
--
STATus:OPERation[:EVENt]?
This command queries the contents of the EVENt section of the STATus:OPERation register. The
contents of the EVENt section are deleted after readout.
Example: "STAT:OPER?"
Characteristics: *RST value: –
SCPI: conforming
Mode: all
STATus:OPERation:CONDition?
This command queries the CONDition section of the STATus:OPERation register. Readout does not
delete the contents of the CONDition section. The value returned reflects the current hardware
status.
Example: "STAT:OPER:COND?"
Characteristics: *RST value: –
SCPI: conforming
Mode: all
STATus:OPERation:ENABle 0 to 65535
This command sets the bits of the ENABle section of the STATus:OPERation register. The ENABle
register selectively enables the individual events of the associated EVENt section for the summary bit
in the status byte.
Example: "STAT:OPER:ENAB 65535"
Characteristics: *RST value: –
SCPI: conforming
Mode: all
STATus:OPERation:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:OPERation register from 0 to 1 for
the transitions of the CONDition bit.
Example: "STAT:OPER:PTR 65535"
Characteristics: *RST value: –
SCPI: conforming
Mode: all