Operating instructions

R&S ESCI SYSTem Subsystem
1166.6004.12 6.221 E-1
SYSTem:PRESet
This command initiates an instrument reset.
The effect of this command corresponds to that of the PRESET key with manual control or to the
*RST command.
Example: "SYST:PRES"
Characteristics: *RST value: –
SCPI: conforming
Mode: all
SYSTem:PRESet:COMPatible FSP | OFF
This command determines if the settings of the receiver after a reset are compatible to the settings
of the R&S FSP (selection FSP). If OFF is selected, the reciever specific settings are active after a
reset.
Example: "SYST:PRES:COMP FSP"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: all
SYSTem:SPEaker:VOLume 0 to 1
This command sets the volume of the built-in loudspeaker for demodulated signals. Minimum
volume is set by 0 and maximum volume by 1.
The value 0 is the lowest volume, the value 1 the highest volume.
Example: "SYST:SPE:VOL 0.5"
Characteristics: *RST value: 0
SCPI: device-specific
Mode: all
SYSTem:TIME 0 to 23, 0 to 59, 0 to 59
This command sets the internal clock. The sequence of entry is hour, minute, second.
Example: "SYST:TIME 12,30,30"
Characteristics: *RST value: –
SCPI: conforming
Mode: all
SYSTem:VERSion?
This command queries the number of the SCPI version, which is relevant for the instrument.
Example: "SYST:VERS?"
Characteristics: *RST value: –
SCPI: conforming
Mode: all
This command is a query and therefore has no *RST value.