Operating instructions

R&S ESCI TRIGger Subsystem
1166.6004.12 6.235 E-1
TRIGger<1|2>[:SEQuence]:LEVel:PM -1000...+1000RAD
The command sets the level when PM-modulated signals are used as a trigger source.
Note: To ensure successful triggering with trigger sources AF, AM FM and PM, the measurement
time should include at least 5 periods of the audio signal.
Example: "TRIG:LEV:PM 1.2 RAD" 'Sets the PM trigger threshold to 1.2 rad
Characteristics: *RST value: 0 RAD
SCPI: device-specific
Mode: FM
This command is only available with option R&S FS-K7 (FM Demodulator) installed.
TRIGger<1|2>[:SEQuence]:LEVel:IFPower -30 to –10DBM
This command sets the level of the IF power trigger source.
Example: "TRIG:LEV:IFP –20DBM"
Characteristics: *RST value: -20 DBM
SCPI: device-specific
Mode: all, except for FM
TRIGger<1|2>[:SEQuence]:LEVel:RFPower -50 to –10DBM
This command sets the level of the RF power trigger source.
Example: "TRIG:LEV:RFP –20DBM"
Characteristics: *RST value: -20 DBM
SCPI: device-specific
Mode: all, except for FM
This command is only available with option R&S FSP-B6 (TV and RF Trigger).
TRIGger<1|2>[:SEQuence]:LEVel:VIDeo 0 to 100PCT
This command sets the level of the video trigger source.
Example: "TRIG:LEV:VID 50PCT"
Characteristics: *RST value: 50 PCT
SCPI: device-specific
Mode: all, except for FM
TRIGger<1|2>[:SEQuence]:HOLDoff -100 to 100s
This command defines the length of the trigger delay.
A negative delay time (pretrigger) can be set in the time domain (span < 0 Hz) only.
Example: "TRIG:HOLD 500us"
Characteristics: *RST value: 0s
SCPI: conforming
Mode: all