Operating instructions

IEC/IEEE-Bus Commands of HP Models R&S ESCI
1166.6004.12 6.252 E-1
Function
Category
Function HP 856xE /
HP 8566B /
HP 8568B /
HP 8594E
Command
Supported Command Subset Known Differences
Reference Level RL RL <numeric_value> DB|DM
RL DN
RL UP
RL?
Step size and default value
Reference Level
Position
RLPOS
1)
RLPOS <numeric_value>
RLPOS DN
RLPOS UP
RLPOS?
On the R&S ESCI, this function affects
the reference level position also if
tracking generator normalization is
inactive.
Reference Level
Offset
ROFFSET ROFFSET <numeric_value>
DB | DM
ROFFSET?
DISP:WIND:TRAC:Y:RLEV:OFFS
<number> dB
Auxiliary Control
AF Demodulator
DEMOD
1)
DEMOD ON|OFF|AM|FM
Normalized
Reference Level
NRL
1)
NRL <numeric_value> DB | DM
NRL?
Requires option R&S FSP-B9 or R&S
FSP-B10.
Source Normalization
SRCNORM
1)
SRCNORM ON|OFF
SRCNORM 1|0
Requires option R&S FSP-B9 or R&S
FSP-B10.
Source Power Offset
SRCPOFS
1)
SRCPOFS <numeric_value>
DB | DM
SRCPOFS DN
SRCPOFS UP
SRCPOFS?
Requires option R&S FSP-B10.
Source Power
SRCPWR
1)
SRCPWR <numeric_value> DB
| DM
SRCPWR DN
SRCPWR UP
SRCPWR ON
SRCPWR OFF
SRCPWR?
Requires option R&S FSP-B9 or R&S
FSP-B10.
Bandwidth
Resolution Bandwidth RB RB <numeric_value>
HZ|KHZ|MHZ|GHZ
RB DN
RB UP
RB AUTO
RB?
Range of values
Formula for dependent parameters
(video bandwidth, sweeptime)
Video Bandwidth VB VB <numeric_value>
HZ|KHZ|MHZ|GHZ
VB DN
VB UP
VB AUTO
VB?
Range of values
Formula for dependent parameters
(sweeptime)
Video Bandwidth
Ratio
VBR
1)
VBR <numeric_value>
VBR DN
VBR UP
VBR?
Default value
Calibration
Start Analyzer Self
Alignment
CAL
1)
CAL ALL
CAL ON
CAL OFF
The CAL commands do not
automatically set the command
complete bit (bit 4) in the status byte. An
additional DONE is required for that
purpose.
1)
HP8594Eonly