Operating instructions

R&S ESCI IEC/IEEE-Bus Commands of HP Models
1166.6004.12 6.253 E-1
Function
Category
Function HP 8590
Command
Supported Command Subset Known Differences
Configuration
Time Display
TIMEDSP
1)
TIMEDSP ON|OFF
TIMEDSP 1|0
TIMEDSP?
Display
Annotation ANNOT ANNOT ON|OFF
ANNOT 1|0
ANNOT?
Only frequency axis annotation is affected.
Threshold TH TH <numeric_value> DB|DM
TH DN
TH UP
TH ON
TH OFF
TH AUTO
TH?
Default value is different.
Threshold line has no effect on trace data
(TH AUTO is always active).
Frequency
Center Frequency CF CF <numeric_value>
HZ|KHZ|MHZ|GHZ
CF UP
CF DN
CF?
Default value
Range
Step size
Start Frequency FA FA <numeric_value>
HZ|KHZ|MHZ|GHZ
FA UP
FA DN
FA?
Range
Step size
Stop Frequency FB FB <numeric_value>
HZ|KHZ|MHZ|GHZ
FB UP
FB DN
FB?
Default value
Range
Step size
Frequency Offset
FOFFSET
1)
FOFFSET <numeric_value>
HZ|KHZ|MHZ|GHZ
FOFFSET?
CF Step Size SS SS <numeric_value>
HZ|KHZ|MHZ|GHZ
SS DN
SS UP
SS AUTO
SS?
Step size
Information
Clear All Status Bits
CLS
1)
CLS
Identify ID ID
ID?
Firmware revision REV REV
REV?
Service Request Bit
Mask
RQS RQS Bits supported:
1 (units key pressed)
2 (end of sweep)
3 (device error)
4 (command complete)
5 (illegal command)
1)
HP8594E only