Operating instructions

R&S ESCI IEC/IEEE-Bus Commands of HP Models
1166.6004.12 6.263 E-1
Model-Dependent Default Settings
When the IEC/IEEE-bus language is switched over to an 85xx model, the IEC/IEEE-bus address will
automatically be switched over to 18 provided that the default address of the R&S ESCI (20) is still set.
If a different value is set, this value will be maintained. Upon return to SCPI, this address will remain
unchanged.
The following table shows the default settings obtained after switchover of the IEC/IEEE-bus language
and for the commands IP, KST and RESET:
Model # of Trace
Points
Start Freq. Stop Freq. Ref Level Input
Cou
p
lin
g
8566A/B 1001 2 GHz 22 GHz 0 dBm DC (ESCI)
AC (ESPI)
8568A/B 1001 0 Hz 1.5 GHz 0 dBm AC
8560E 601 0 Hz 2.9 GHz 0 dBm AC
8561E 601 0 Hz 6.5 GHz 0 dBm AC
8562E 601 0 Hz 13.2 GHz 0 dBm AC
8563E 601 0 Hz 26.5 GHz 0 dBm AC
8564E 601 0 Hz 40 GHz 0 dBm AC
8565E 601 0 Hz 50 GHz 0 dBm AC
8594E 401 0 Hz 3 GHz 0 dBm AC
Note regarding the set stop frequency:
The stop frequency given in the table may be limited to the corresponding frequency range of the R&S
ESCI.
Note regarding the number of test points (trace points):
The # of trace points is switched over only upon transition to the REMOTE state.