Operating instructions

R&S ESCI Status Reporting System
1166.6004.12 5.25 E-1
STATus:QUEStionable:ACPLimit Register
This register comprises information about the observance of limits during adjacent power
measurements. It can be queried with commands 'STATus:QUEStionable:ACPLimit
:CONDition?' and 'STATus:QUEStionable:ACPLimit[:EVENt]?'
Table 5-6 Meaning of bits in STATus:QUEStionable:ACPLimit register
Bit No. Meaning
0
ADJ UPPer FAIL(Screen A)
This bit is set if in screen A. the limit is exceeded in the upper adjacent channel
1
ADJ LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower adjacent channel.
2
ALT1 UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the upper 1st alternate channel.
3
ALT1 LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower 1st alternate channel.
4
ALT2 UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the upper 2nd alternate channel.
5
ALT2 LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower 2nd alternate channel.
6 to 7 not used
8
ADJ UPPer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the upper adjacent channel.
9
ADJ LOWer FAIL (Screen B)
This bit is set if in screen
B the limit is exceeded in the lower adjacent channel.
10
ALT1 UPPer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the upper 1st alternate channel.
11
ALT1 LOWer FAIL (Screen B)
This bit is set if
in screen B the limit is exceeded in the lower 1st alternate channel.
12
ALT2 UPPer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the upper 2nd alternate channel.
13
ALT2 LOWer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the lower 2nd alternate channel.
14 not used
15 This bit is always set to 0.