Operating instructions

Instrument Interfaces R&S ESCI
1166.6004.12 8.10 E-1
Hardware handshake
For hardware handshake, the instrument indicates that it is ready to receive data via the lines DTR and
RTS. A logic '0' on both lines means 'ready' and a logic '1' means 'not ready'. The RTS line is always
active (logic '0') as long as the serial interface is switched on. The DTR line thus controls the readiness
of the instrument to receive data.
The readiness of the remote station to receive data is reported to the instrument via the CTS and DSR
line. A logic '0' on both lines activates the data output and a logic '1' on both lines stops the data output
of the instrument. The data output takes place via the TxD line.
Cable for hardware handshake
The connection of the instrument to a controller is made with a so-called zero modem cable. Here, the
data, control and acknowledge lines must be crossed. The following wiring diagram applies to a
controller with a 9-pin or 25-pin configuration.
Instrument Controller Instrument Controller
9-pin 9-pin 9-pin 25-pin
1
2
3
4
5
6
7
8
9
------------RxD / TxD---------------
------------TxD / RxD---------------
------------DTR /DSR---------------
------------GND / GND-------------
------------DSR / DTR--------------
------------RTS / CTS--------------
------------CTS / RTS--------------
1
3
2
6
5
4
8
7
9
1
2
3
4
5
6
7
8
9
------------RxD / TxD---------------
------------TxD / RxD---------------
------------DTR /DSR---------------
------------GND / GND-------------
------------DSR / DTR--------------
------------RTS / CTS--------------
------------CTS / RTS--------------
8
2
3
6
7
20
5
4
22
Fig. 8-7 Wiring of the data, control and acknowledge lines for hardware handshake
User Interface (USER)
The user interface, located on the rear panel of the , is a 25 pin Cannon connector which provides
access to the user ports (Port A). The port is 8 bits wide (A0 - A7) and can be configured either as
output or as input. The voltage levels are TTL levels (Low < 0,4 V, High > 2 V).
In addition, an internal +5 V power supply voltage is provided. The maximum load current is 100 mA
The pin assignments for the USER connector can be seen in the following diagram:
1
14
13
25
A0
A1
A2
A3
A4
A5
A6
A7
GND
GND
GND
+5 V
+12 V
Fig. 8-9 Pin assignments for the USER connector.
The configuration of the user ports takes place in the SETUP menu (SETUP key) in the GENERAL
SETUP sub-menu.