Operating instructions

CALCulate:LIMit Subsystem R&S ESCI
1166.6004.12 6.32 E-1
CALCulate<1|2>:LIMit<1 to 8>:CONTrol:OFFSet <numeric_value>
This command defines an offset for the X axis value of the selected relative limit line in the frequency
or time domain.
The unit of values depends on the frequency or time domain of the X axis, i.e. it is HZ with
CALC:LIM:CONT:DOM FREQ und S bei CALC:LIM:CONT:DOM TIME.
Example: "CALC:LIM2:CONT:OFFS 100us" 'Sets the X offset for limit line 2 (defined in
'the time domain) to 100µs.
Characteristics: *RST value: 0
SCPI: device-specific
Mode: A, FM
CALCulate<1|2>:LIMit<1 to 8>:CONTrol:MODE RELative | ABSolute
This command selects the relative or absolute scaling for the X axis of the selected limit line. The
definition is independent of the measurement window.
Example: "CALC:LIM2:CONT:MODE REL" 'Defines the X axis of limit line 2 as relatively
'scaled.
Characteristics: *RST value: ABSolute
SCPI: device-specific
Mode: A, FM
CALCulate<1|2>:LIMit<1 to 8>:CONTrol:SHIFt <numeric_value>
This command moves a limit line by the indicated value in x direction. In contrast to
CALC:LIM:CONT:OFFS, the line is shifted by modifying the individual x values and not by means of
an additive offset. The shift is independent of the measurement window.
In the analyzer mode, the unit of values depends on the frequency or time domain of the X axis, i.e. it
is HZ with CALC:LIM:CONT:DOM FREQ und S bei CALC:LIM:CONT:DOM TIME.
Example: "CALC:LIM2:CONT:SHIF 50KHZ" 'Shifts all reference values of limit line 2 by
'50 kHz.
Characteristics: *RST value: --
SCPI: device-specific
Mode: R, A, FM
This command is an event and therefore has no *RST value and no query.
CALCulate<1|2>:LIMit<1...8>:CONTrol:SPACing LINear | LOGarithmic
This command selects linear or logarithmic interpolation for the calculation of limit lines from
frequency points.
Example: "CALC:LIM:CONT:SPAC LIN"
Characteristics: *RST value: LIN
SCPI: device-specific
Modes: R, A