User Manual

Remote Commands
R&S
®
FPL1000
791User Manual 1178.3370.02 ─ 09
Suffix:
<ip>
.
1 | 2
irrelevant
Parameters:
<State> ON | 1
User port is switched to INPut
OFF | 0
User port is switched to OUTPut
*RST: 1
INPut<ip>:UPORt[:VALue]
This command queries the control lines of the user ports.
For details see OUTPut<up>:UPORt[:VALue] on page 809.
Suffix:
<ip>
.
1 | 2
irrelevant
Return values:
<Level> bit values in hexadecimal format
TTL type voltage levels (max. 5V)
Range: #B00000000 to #B00111111
Example:
INP:UPOR?
//Result: #B00100100
Pins 5 and 7 are active.
11.8.5.2 Working with Power Sensors
The following commands describe how to work with power sensors.
These commands require the use of a Rohde & Schwarz power sensor. For a list of
supported sensors, see the data sheet.
The [Sensor] connector is provided by the "Additional Interfaces" option R&S FPL1-B5.
Additionally, the power sensor measurement requires the option R&S FPL1-K9.
● Configuring Power Sensors.................................................................................. 791
● Configuring Power Sensor Measurements........................................................... 793
Configuring Power Sensors
SYSTem:COMMunicate:RDEVice:PMETer<p>:CONFigure:AUTO[:STATe]........................... 792
SYSTem:COMMunicate:RDEVice:PMETer<p>:COUNt?.....................................................792
SYSTem:COMMunicate:RDEVice:PMETer<p>:DEFine...................................................... 792
Setting Basic Spectrum RF Measurement Parameters