User Manual

Instrument Tour
R&S
®
FPL1000
43Getting Started 1323.1602.02 ─ 03
Function key Assigned functions
PEAK Performs a peak search for active marker. If no marker is active,
normal marker 1 is activated and the peak search is performed
for it.
RUN SINGLE Starts and stops a single new measurement (Single Sweep
Mode)
RUN CONT Starts and stops a continuous measurement (Continuous Sweep
Mode)
4.1.6 Keypad
The keypad is used to enter numeric parameters, including the corresponding
units. It contains the following keys:
Table 4-3: Keys on the keypad
Type of key Description
Decimal point Inserts a decimal point "." at the cursor position.
Sign key Changes the sign of a numeric parameter. In the case of an
alphanumeric parameter, inserts a "-" at the cursor position.
Unit keys
(GHz/-dBm MHz/dBm,
kHz/dB, Hz/dB etc.)
Adds the selected unit to the entered numeric value and com-
plete the entry.
In the case of level entries (e.g. in dB) or dimensionless values,
all units have the value "1" as multiplying factor. Thus, they have
the same function as an ENTER key.
ESC Closes all kinds of dialog boxes, if the edit mode is not active.
Quits the edit mode, if the edit mode is active. In dialog boxes
that contain a "Cancel" button it activates that button.
For "Edit" dialog boxes the following mechanism is used:
●
If data entry has been started, it retains the original value
and closes the dialog box.
●
If data entry has not been started or has been completed, it
closes the dialog box.
Front Panel View