User Manual

Instrument Tour
R&S
®
FPL1000
51Getting Started 1323.1602.02 ─ 03
For details, see the User Manual.
4.2.13 Noise Source Control
The Noise Source Control female connector is used to provide the supply voltage
for an external noise source. For example, use it to measure the noise figure and
gain of amplifiers and frequency converting devices.
This connector is only available if the R&S FPL1-B5 option is installed.
Conventional noise sources require a voltage of +28 V to be switched on and 0 V
to be switched off. The output supports a maximum load of 100 mA.
Rear Panel View