User Manual

Remote Commands
R&S
®
FPL1000
1010User Manual 1178.3370.02 ─ 09
TRIGger[:SEQuence]:EXTernal1:DELay:STATe[?] OFF | ON | 0 | 1
TRIGger[:SEQuence]:EXTernal2:LEVel[?] <level>
TRIGger[:SEQuence]:EXTernal1:LEVel[?] <level>
TRIGger[:SEQuence]:EXTernal2:SLOPe[?] POSitive | NEGative
TRIGger[:SEQuence]:EXTernal1:SLOPe[?] POSitive | NEGative
TRIGger[:SEQuence]:IF:LEVel[?]
TRIGger[:SEQuence]:IF:SLOPe[?] NEGative | POSitive
TRIGger[:SEQuence]:SOURCe EXTernal | IMMediate | VIDeo | LINE | EXTernal1 | EXT1 | EXTernal2 |
EXT2 | RFBurst | FRAMe
TRIGger[:SEQuence]:VIDeo:DELay[?] <time>
TRIGger[:SEQuence]:VIDeo:DELay:STATe[?] OFF | ON | 0 | 1
TRIGger[:SEQuence]:VIDeo:LEVel[?] <ampl>
TRIGger[:SEQuence]:VIDeo:SLOPe[?] POSitive | NEGative
11.12 Using the Status Register
For more information on the contents of the status registers see:
●
"STATus:OPERation Register" on page 565
●
"STATus:QUEStionable:ACPLimit Register" on page 567
●
"STATus:QUEStionable:EXTended Register" on page 568
●
"STATus:QUEStionable:FREQuency Register" on page 569
●
"STATus:QUEStionable:LIMit Register" on page 570
●
"STATus:QUEStionable:LMARgin Register" on page 570
●
"STATus:QUEStionable:POWer Register" on page 571
●
"STATus:QUEStionable:TEMPerature Register" on page 572
●
"STATus:QUEStionable:TIMe Register" on page 572
● General Status Register Commands.................................................................. 1010
● Reading Out the CONDition Part........................................................................ 1011
● Reading Out the EVENt Part...............................................................................1012
● Controlling the ENABle Part................................................................................1012
● Controlling the Negative Transition Part............................................................. 1013
● Controlling the Positive Transition Part............................................................... 1013
● Service Request..................................................................................................1014
11.12.1 General Status Register Commands
STATus:PRESet...........................................................................................................1011
STATus:QUEue[:NEXT]?...............................................................................................1011
Using the Status Register