User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
134User Manual 1178.3370.02 ─ 09
The remote commands required to perform these tasks are described in Chap-
ter 11.6.4, "Measuring the Channel Power and ACLR", on page 638.
● General CP/ACLR Measurement Settings............................................................134
● Channel Setup...................................................................................................... 138
General CP/ACLR Measurement Settings
General measurement settings are defined in the "ACLR Setup" dialog, in the "General
Settings" tab.
Standard......................................................................................................................135
└ Predefined Standards................................................................................... 135
└ User Standards.............................................................................................135
Number of channels: Tx, Adj.......................................................................................136
Reference Channel..................................................................................................... 136
Selected Trace............................................................................................................ 137
Absolute and Relative Values (ACLR Mode).............................................................. 137
Channel power level and density (Power Unit)........................................................... 137
Power Mode................................................................................................................137
Setting a fixed reference for Channel Power measurements (Set CP Reference)..... 137
Optimized Settings (Adjust Settings)...........................................................................138
Sweep Time................................................................................................................ 138
Measurements and Results