User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
220User Manual 1178.3370.02 ─ 09
Note: You can define the time values with a greater numerical resolution than is dis-
played; the values are only rounded for display.
Remote command:
[SENSe:]SWEep:EGATe:TRACe<t>:STARt<gr> on page 704
[SENSe:]SWEep:EGATe:TRACe<t>:STOP<gr> on page 705
Scaling for Statistics Diagrams
Access: "Overview" > "Amplitude" > "Scale" tab
Or: [AMPT] > "Scale Config"
For statistics displays, scale settings are available for both the y-axis and the x-axis.
The remote commands required to perform these tasks are described in Chap-
ter 11.6.9.4, "Scaling the Diagram", on page 705.
Figure 7-32: Scale settings for CCDF diagram
In statistical diagrams, the x-axis displays the signal level values (= y-axis in standard
display), while the y-axis displays the probability of the values.
X-Axis..........................................................................................................................221
└ Ref Level.......................................................................................................221
└ Range........................................................................................................... 221
└ Shifting the Display (Offset).......................................................................... 221
Y-Axis.......................................................................................................................... 221
└ Y-Unit............................................................................................................ 221
└ Y-Max/ Y-Min.................................................................................................221
Default Settings...........................................................................................................221
Adjust Settings............................................................................................................ 222
Measurements and Results