User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
228User Manual 1178.3370.02 ─ 09
between signal and noise power of a TDMA signal for instance can be measured by
using a measurement as a reference value and then varying the measurement range.
In order to get stable measurement results for a limited evaluation range, usually a trig-
ger is required.
7.2.10.4 Time Domain Power Configuration
Access: "Overview" > "Select Measurement" > "Time Domain Power" > "Time Dom
Power Config"
The remote commands required to perform these tasks are described in Chap-
ter 11.6.10, "Measuring the Time Domain Power", on page 711.
Results........................................................................................................................ 229
Limit State................................................................................................................... 229
Left Limit / Right Limit..................................................................................................229
Measurements and Results