User Manual

Getting Started
R&S
®
FPL1000
23User Manual 1178.3370.02 ─ 09
However, it is not recommended to operate the R&S FPL1000 with only one battery for
a longer period.
5.1.6 Switching On or Off
Table 5-1: Overview of power states
Status LED on Power key Position of main power switch
Off
gray
[0]
Standby
orange
[I]
Ready
green
[I]
To switch on the R&S FPL1000
The R&S FPL1000 is off but connected to power.
1. Set the switch on the power supply to position [I].
See Chapter 5.2.2.2, "AC Power Supply Connection and Main Power Switch",
on page 38.
The LED of the Power key is orange.
See Chapter 5.2.1.2, "Power Key", on page 33.
2. Press the Power key.
See Table 5-1.
The LED changes to green.
The instrument operates on battery, DC, or AC power, whichever is supplied. The
R&S FPL1000 boots.
After booting, the instrument is ready for operation.
To shut down the product
The product is in the ready state.
► Press the Power key.
The operating system shuts down. The LED changes to orange.
To disconnect from power
The R&S FPL1000 is in the standby state.
1.
NOTICE! Risk of data loss. If you disconnect the product from power when it is in
the ready state, you can lose settings and data. Shut it down first.
Set the switch on the power supply to position [0].
See Chapter 5.2.2.2, "AC Power Supply Connection and Main Power Switch",
on page 38.
The LED of the standby key is switched off.
Preparing for Use