User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
292User Manual 1178.3370.02 ─ 09
Tracking Generator Settings
Access: Toolbar > "Generator Config"
Or: [Freq] > "Generator Config"
The tracking generator signal is only available for frequency sweeps in the Spectrum
application, and only if the optional Internal Generator R&S FPL1-B9 is installed.
The preview in the dialog box visualizes the configured signal from the internal tracking
generator.
For details, see Chapter 7.3.3.1, "Basics on the Internal Generator", on page 283.
Usage..........................................................................................................................292
State............................................................................................................................293
Level............................................................................................................................293
Level Offset.................................................................................................................293
Frequency................................................................................................................... 293
Frequency Offset.........................................................................................................293
Calibrate Transmission................................................................................................293
Calibrate Reflection Short........................................................................................... 294
Calibrate Reflection Open...........................................................................................294
Normalization state..................................................................................................... 294
Reference Position......................................................................................................294
Reference Value..........................................................................................................295
Recall Cal. Settings.....................................................................................................295
Save as Trd Factor......................................................................................................295
Usage
Determines the type of signal provided by the internal generator:
●
"Independent CW source" on page 283: constant frequency and power level
Receiving Data Input and Providing Data Output