User Manual

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
296User Manual 1178.3370.02 ─ 09
For details, see Chapter 7.3.3.1, "Basics on the Internal Generator", on page 283.
Usage..........................................................................................................................296
State............................................................................................................................296
Level Offset.................................................................................................................297
Frequency Offset.........................................................................................................297
Level Start / Level Stop...............................................................................................297
Calibrate Transmission................................................................................................297
Normalization state..................................................................................................... 297
Usage
Determines the type of signal provided by the internal generator:
●
"Independent CW source" on page 283: constant frequency and power level
●
"Tracking generator" on page 284: constant power level, frequency follows ana-
lyzer frequency (only available for frequency sweeps in the Spectrum application)
●
"Power sweep" on page 284: constant frequency, linearly increasing power level
(only available in the Spectrum application)
Remote command:
SOURce<si>:FREQuency:COUPling[:STATe] on page 802
SOURce<si>:POWer:MODE on page 805
State
Enables or disables the internal generator. The generator signal is output at the GEN
Output 50 Ω connector on the front panel.
Remote command:
OUTPut<up>[:STATe] on page 800
Receiving Data Input and Providing Data Output